Camry Sedan L4-2.0L (3S-FE) (1987)
c. Finger tighten the four bolts first. Tighten them with a torque wrench.
Torque: 100 kg.cm (7 ft.lb, 10 N.m)
NOTE: Each bolt length (mm) is indicated in the figure.
7. INSTALL DETENT SPRING
NOTE: Each bolt length (mm) is indicated in the figure.
a. Finger tighten all the bolts first. Then tighten with a torque wrench.
Torque: 100 kg.cm (7 ft.lb, 10 N.m)
b. Check that the manual valve lever is in contact with the center of the roller at the tip of the detent spring.
8. INSTALL OIL TUBES
Tap the tubes into the positions indicated in the figure with a plastic hammer.
CAUTION: Be careful not to bend or damage the tubes.
9. INSTALL APPLY TUBE BRACKET