Camry Sedan 2-Door V6-3.0L (1MZ-FE) (1994)
4. INSPECT SIDE GEAR BACKLASH
Using a dial indicator, measure the backlash of one side gear while holding one pinion toward the case.
Standard backlash: 0.05 - 0.20 mm (0.0020 - 0.0079 in.)
If the backlash does not meet specification, install the correct thrust washer to the side gears.
5. DISASSEMBLY DIFFERENTIAL CASE
a. Using a pin punch and hammer, drive out the straight pin.
b. Remove the pinion shaft from the case.
c. Remove the 2 pinions and 2 side gears with the 4 thrust washers from each gear.
6. TRANSMISSION CASE SIDE:
IF NECESSARY, REPLACE DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL