Camry Wagon L4-2.0L (3S-FE) (1990)
(b) Check the flow control valve for leakage.
Close one of the holes and apply compressed air [4 - 5 kg/cm2 (57 - 71 psi, 392 490 kpa)] into the opposite side, and confirm that air does not
come out from the end holes.
If necessary, replace the valve with one having the same letter as inscribed on the front housing.
Inscribed mark: A,B,C,D,E or F
4. INSPECT FLOW CONTROL SPRING
Using a scale, measure the free length of the spring.
Spring length: 36 - 38 mm (1.42-1.49 in.)
If not within specification, replace the spring.
5. IF NECESSARY, REPLACE OIL SEAL
(a) Using a screwdriver, pry out the oil seal.