Camry Wagon L4-2.0L (3S-FE) (1990)
INSPECTION OF FORWARD CLUTCH
1. INSPECT CLUTCH PISTON
a. Check that the check ball is free by shaking the piston.
b. Check that the valve does not leak by applying low- pressure compressed air.
2. INSPECT DISCS, PLATES AND FLANGE
Check if the sliding surfaces of the discs, plates and flange are worn or burnt. If necessary, replace them.
HINT:
-
If the lining of the disc is exfoliated or discolored, or even a part of the printed numbers are defaced, replace all discs.
-
Before assembling new discs, soak them in ATF for at least two hours.
ASSEMBLY OF FORWARD CLUTCH
1. INSTALL OIL SEAL RINGS
Install the two oil seal rings to the shaft.
NOTE: Do not spread the ring ends more than necessary.
HINT: After installing the oil seal rings, check that they move smoothly.
2. INSTALL CLUTCH PISTON TO CLUTCH DRUM