Camry Wagon L4-2.0L (3S-FE) (1990)
b. Tighten the adjusting nut until the following gear starting load occurs with a tension gauge.
Pre load (at starting): 920 - 1,530 g
(2.0 - 3.4 lb, 9 - 15 N)
HINT: Turn the counter drive gear right and left several times before measuring the preload.
c. Lock the adjusting nut with one tab on locking washer. Bend the locking washer tab until it is even with the adjusting nut groove.
9. INSTALL PINION SHAFT PLUGS
Install the four plugs into the pinion shaft.
10. INSTALL NO.3 OVERDRIVE PLANETARY THRUST WASHER
Install the thrust washer, facing the groove toward the overdrive case.
11. ASSEMBLE OVERDRIVE ONE-WAY CLUTCH