Camry Wagon L4-2.0L (3S-FE) (1990)
a. Install the one-way clutch into the outer race.
b. Install a retainer on both sides of the one-way clutch.
12. INSTALL OVERDRIVE ONE-WAY CLUTCH INTO HUB
Be sure that the one-way clutch is installed in the correct direction.
13. INSTALL RETAINING PLATE
a. Place the retaining plate into the hub.
b. Install the snap ring with a screwdriver.
14. CHECK OPERATION OF ONE-WAY CLUTCH
a. While turning the overdrive gear clockwise, install the overdrive direct clutch into the one-way clutch.
b. Hold the overdrive direct clutch and turn the intermediate shaft. The shaft should turn freely clockwise and should lock counterclockwise.
c. Remove the overdrive direct clutch.
DISASSEMBLY OF OVERDRIVE CASE
1. REMOVE C0 ACCUMULATOR PISTON FROM OVERDRIVE CASE