Camry Wagon V6-180.5 2959cc 3.0L DOHC (3VZ-FE) (1993)
/Page-973013.png)
Preload (at starting):
New bearing (Add output shaft preload)
0.2 - 0.4 N.m (2.0 - 4.1 kgf-cm, 1.7 - 3.6 in.-lbf)
Reused bearing (Add output shaft preload)
0.1 - 0.2 N.m (1.3 - 2.5 kgf-cm, 1.1 - 2.2 in.-lbf)
If the preload is not within specification, select the thrust washers.
HINT: The total preload will change about 0.1 - 0.2 N.m (1 - 2 kgf-cm, 0.9 - 1.7 ft-lbf) with each shim thickness.
12. REMOVE REAR BEARING RETAINER
Using torx wrench, remove the seven torx screws and rear bearing retainer.
Torx wrench T45 09042-00050
13. REMOVE SHIM
14. REMOVE TRANSMISSION CASE
a. Remove the seventeen bolts.
b. Using a plastic hammer, tap off the transmission case.
15. REMOVE OUTPUT SHAFT ASSEMBLY
16. REMOVE DIFFERENTIAL CASE ASSEMBLY