Camry Wagon V6-180.5 2959cc 3.0L DOHC (3VZ-FE) (1993)
/Page-973012.png)
9. INSTALL SHIM
HINT: Install the previously selected shim.
10. INSTALL REAR BEARING RETAINER
Using a torx wrench, install and torque the seven torx screws.
Torx wrench T45 09042-00050
Torque: 42 N.m (430 kgf-cm, 31 ft-lbf)
11. ADJUST DIFFERENTIAL CASE SIDE BEARING PRELOAD
a. Install the new lock nut to the output shaft.
b. Turn the output shaft right and left two or three times to allow the bearings to settle.
c. Using a small torque wrench, measure the preload.