Celica GT Liftback L4-2164cc 2.2L DOHC (5S-FE) MFI (1999)
![background image](/toyota/celica_gt_liftback/l4-2164cc_2.2l_dohc_(5s-fe)_mfi/Page-1296008.png)
a. Coat a new O-ring with power steering fluid and install it to the union.
b. Torque the union.
Torque: 69 Nm (700 kgf-cm, 51 ft. lbs.)
14. INSTALL SUCTION PORT UNION
a. Coat a new O-ring with power steering fluid and install it to the union.
b. Torque the union.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
15. INSTALL PRESSURE FEED NO.2 TUBE
Torque the union bolt with a new gasket on each side of the tube.
Torque: 69 Nm (700 kgf-cm, 51 ft. lbs.)
HINT: Pressure feed No.2 tube installation angle is 35°.
16. INSTALL AIR CONTROL VALVE
a. Install a new union seat.
b. Torque the valve.
Torque: 36 Nm (370 kgf-cm, 27 ft. lbs.)
17. INSTALL VANE PUMP PULLEY
a. Install the woodruff key to the vane pump shaft.
b. Using SST to stop the pulley rotating, torque the nut.
SST 09960-10010 (09962-01000, 09963-01000)
Torque: 43 Nm (440 kgf-cm, 32 ft. lbs.)
18. MEASURE PS VANE PUMP ROTATING TORQUE