Celica GT Liftback L4-2164cc 2.2L DOHC (5S-FE) MFI (1999)
6. INSTALL VANE PUMP SHAFT WITH VANE PUMP ROTOR AND SIDE FRONT PLATE
a. To prevent oil seal lip damage, wind vinyl tape on the shaft.
b. Align the hole of the plate and longer straight pin, and lap in the shaft with a plastic hammer.
NOTICE: Be careful not to damage the oil seal and O-rings.
7. INSTALL CAM RING
Align the holes of the ring and 2 straight pins, and install the ring with the inscribed mark facing outward.
8. INSTALL VANE PLATES
Install the 10 plates with the round end facing outward.
9. INSTALL SIDE REAR PLATE
a. Coat a new O-ring with power steering fluid and install it to the plate.
b. Align the holes of the plate and 2 straight pins.
10. INSTALL WAVE WASHER
Install the washer so that its protrusions fit into the slots in the side rear plate.
11. INSTALL REAR HOUSING
a. Coat a new O-ring with power steering fluid and install it to the housing.
b. Install a new snap ring to the front housing.
12. INSTALL SPRING AND FLOW CONTROL VALVE
Install the valve facing the correct direction.
13. INSTALL PRESSURE PORT UNION