Corolla L4-2.4L (2AZ-FE) (2010)
NOTICE:
The resistance must be measured after the CAN No. 2 junction connector is disconnected.
Standard Resistance:
NG -- CHECK FOR SHORT IN CAN BUS WIRES (CAN NO. 2 JUNCTION CONNECTOR - ECM MAIN WIRE)
OK -- Continue to next step.
4. CHECK FOR SHORT IN CAN BUS WIRES (CAN NO. 2 JUNCTION CONNECTOR - SKID CONTROL ECU)
(a) Disconnect the skid control ECU connector.
(b) Measure the resistance according to the value(s) in the table below.
NOTICE:
The resistance must be measured after the skid control ECU connector and CAN No. 2 junction connector are disconnected.
Standard Resistance: