Corolla LE Sedan L4-1.8L (1ZZ-FE) (1999)
Drive shaft standard length:
8. INSTALL INBOARD JOINT BOOT CLAMPS AND OUTBOARD JOINT SMALL BOOT CLAMP
a. Place new clamps to the proper positions.
b. Using pliers, pinch the claw A and B to compress the clamp and engage the claw C and C'.
9. ASSEMBLE OUTBOARD JOINT LARGE BOOT CLAMP
a. Secure the clamp onto the boot.
b. Place SST onto the clamp.
SST 09521-24010
c. Tighten the SST so that the clamp is pinched.
NOTICE: Do not overtighten the SST.
d. Using SST, adjust the clearance of the clamp.
SST 09240-00020
Clearance: 1.9 mm (0.075 inch) or less
10. RH drive shaft: ASSEMBLE DAMPER CLAMP
a. Make sure that the damper is on the shaft groove.
b. Set the distance, as described below.
Distance: 431.3 ± 3.0 mm (16.980 ± 0.118 inch)