Corolla LE Sedan L4-1762cc 1.8L DOHC MFI (1998)
1. Remove steering wheel pad.
NOTICE:
-
If the airbag connector is disconnected with the ignition switch at ON or ACC, DTCs will be recorded.
-
Never use airbag parts from another vehicle. When replacing parts, replace with new ones.
a. Place the front wheels facing straight ahead.
b. Remove the 2 steering wheel lower No.2 covers.
c. Using a torx socket wrench, loosen the 2 torx screws until the groove along the screw circumference catches on the screw case.
d. Pull out the wheel pad from the steering wheel and disconnect the airbag connector.
CAUTION: When storing the wheel pad, keep the upper surface of the pad facing upward. Never disassemble the wheel pad.
NOTICE: When removing the wheel pad, take care not to pull the air bag wire harness.
2. Remove steering wheel.
a. Disconnect the connector.
b. Remove the steering wheel set nut.
c. Place matchmarks on the steering wheel and main shaft assembly.
d. Using Special Service Tool (SST) 09950 - 50010 (09951-05010, 09952-05010, 09950-05020, 09950-05020) or equivalent, remove the wheel.
INSTALLATION
