Corolla Wagon L4-107.5 1762cc 1.8L DOHC (7A-FE) (1993)
INSTALLATION:
1.
Reinstall coil and packing. Tighten coil retaining screws evenly.
CAUTION: Do not use impact or air tools on ignition coil retaining screws.
Ignition Coil Primary Wire Installation
2.
Reconnect the wires to the terminals of the ignition coil.
Ignition Coil Wires
NOTE: Ensure the wires are properly inserted into their grooves, located on the side of the ignition coil. Ensure that the wires don't contact the signal
rotor or distributor housing.
3.
Install the ignition rotor, dust cover, and distributor cap.
4.
Install distributor in vehicle. Refer to DISTRIBUTOR in this section.