Corolla Wagon L4-107.5 1762cc 1.8L DOHC (7A-FE) (1993)
Maximum inside diameter:
Front side 21.57 mm (0.8492 in.)
Rear side 27.07 mm (1.0657 in.)
If the inside diameter is greater than the maximum, replace the stator shaft.
OIL PUMP ASSEMBLY
1. INSTALL FRONT OIL SEAL
Using SST and a hammer, install a new oil seal. The seal end should be flush with the outer edge of the pump body.
SST 09350-32014 (09351-32140)
2. INSTALL DRIVEN GEAR AND DRIVE GEAR
Make sure the top of the gears are facing upward.
3. INSTALL STATOR SHAFT TO PUMP BODY
a. Align the stator shaft with each bolt hole.
b. Torque the eleven bolts.
Torque: 10 N.m (100 kgf.cm, 7 ft.lbf)