Cressida Sedan L6-2759cc 2.8L DOHC (5M-GE) (1986)
/Page-131002.png)
3.
Using tool number 09214-60010 or equivalent and hammer, drive crankshaft sprocket onto crankshaft.
4.
Temporarily install idler pulley and tension spring. Push idler pulley toward the alternator and finger tighten idler pulley bolt.
5.
Install timing belt onto crankshaft sprocket. If belt is being reused, ensure direction of rotation is correct and reference marks made during
removal are aligned.
6.
Install No. 1 timing cover, then the air conditioner compressor bracket.
7.
Install crankshaft pulley. Torque pulley bolt to specifications.
8.
Remove oil filler cap, then exhaust side cylinder head cover and gasket.
9.
Install camshaft sprockets and timing belt, noting the following:
Fig. 110 Aligning hole on No. 2 camshaft journal housing w/No. 2 camshaft journal. 5M-GE engines
Fig. 112 Camshaft sprocket installation. 5M-GE engine
a. Ensure alignment hole on No. 2 camshaft journal housing is aligned with No. 2 camshaft journal, Fig. 110. If not, temporarily install camshaft
sprockets as shown in Fig. 112 and insert alignment pin into pin hole. Turn camshaft sprocket until No. 2 camshaft journal housing and No. 2
camshaft journal holes are aligned.
b. Install camshaft sprockets with timing belt guides facing in the directions shown in Fig. 112.
Fig. 104 Timing belt installation. 3S-GE engine
c. Ensure No. 1 cylinder is at TDC of compression stroke. Align marks on No. 2 timing belt cover with marks on camshaft sprockets, Fig. 104,