Echo L4-1.5L (1NZ-FE) (2000)
/Page-329003.png)
a. Set the jack to the engine.
HINT: Place a wooden block between the jack and engine.
b. w/ ARC: Remove the bolt holding the liquid tube to the RH engine mounting insulator.
c. Remove the 5 bolts, nut and RH engine mounting insulator.
7. REMOVE CYLINDER HEAD COVER
a. Remove the 4 nuts and No.2 cylinder head cover.
b. Remove the ignition coils.
c. Remove the 2 PCV hoses from the cylinder head cover.
d. Remove the 7 bolts, 2 seal washers, 2 nuts, cylinder head cover and gasket.
8. SET NO.1 CYLINDER TO TDC/COMPRESSION
a. Turn the crankshaft pulley, and align its groove with timing mark "0" of the timing chain cover.
