FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
(c) Install the brake booster with accumulator pump assembly.
(d) Install a new clip.
(e) Install the wire harnesses with the 2 screws.
Torque: 2.9 Nm (30 kgf-cm, 26 in-lbf)
(f) Install 2 new plugs.
9. INSTALL BRAKE ACTUATOR NO. 1 TUBE
(a) Using a union nut wrench, install the brake actuator tube.
without union nut wrench - Torque: 15 Nm (155 kgf-cm, 11 ft-lbf)
with union nut wrench - Torque: 14 Nm (144 kgf-cm, 10 ft-lbf)
NOTICE:
-
This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.8 in.) and a union nut wrench with a
fulcrum length of 22 mm (0.866 in.) See: Service Precautions.
-
This torque value is effective when the union nut wrench is parallel to a torque wrench.
10. INSTALL BRAKE ACTUATOR HOSE NO.1
(a) Using needle-nose pliers, install the brake actuator hose with the 2 clips.
11. INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
(a) Apply lithium soap base glycol grease to 3 new grommets.