FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
(b) Install the 3 grommets onto the master cylinder body.
NOTE: The grommets are different sizes. Install the grommets in their correct positions.
(c) Install the master cylinder reservoir with the screw.
Torque: 1.7 Nm (17 kgf-cm, 15 in-lbf)
(d) Using a pin punch and hammer, install a new pin onto the master cylinder reservoir.
12. INSTALL BRAKE ACTUATOR NO. 1 BRACKET
(a) Install the fluid level warning switch connector.
(b) Using a 5 mm hexagon wrench, install the brake actuator bracket with the bolt.
Torque: 7.8 Nm (80 kgf-cm, 69 in-lbf)