FJ Cruiser 2WD V6-4.0L (1GR-FE) (2008)
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE REAR WHEEL
3. REMOVE REAR SPEED SENSOR
(a) Disconnect the skid control sensor wire.
(b) Remove the nut and rear speed sensor.
NOTICE:
-
Do not attach any foreign matter to the sensor tip.
-
Ensure that no foreign matter enters the sensor installation part.
Installation
BRAKE CONTROL: REAR SPEED SENSOR: INSTALLATION
INSTALLATION
1. INSTALL REAR SPEED SENSOR
(a) Install the rear speed sensor with the nut.
Torque: 8.3 Nm (85 kgf-cm, 73 in-lbf)
NOTE: Make sure that the sensor tip is clean.
(b) Connect the skid control sensor wire.
2. INSTALL REAR WHEEL
Torque: 112 Nm (1,137 kgf-cm, 82 ft-lbf)
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 Nm (40 kgf-cm, 35 in-lbf)
4. CHECK VSC SENSOR SIGNAL
See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test
Mode Procedure