FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
7. INSTALL BRAKE PEDAL SUPPORT REINFORCEMENT
(a)
Provisionally install the reinforcement onto the brake pedal support with the bolt and nut.
(b) Install the reinforcement with the bolt.
Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf.)
(c)
Fully tighten the bolt and nut.
Torque: 34 N*m (350 kgf*cm, 25 ft.*lbf.)
8. INSTALL MASTER CYLINDER PUSH ROD CLEVIS
(a)
Apply lithium soap base glycol grease to the inner surface of the hole in the brake pedal lever.
(b) Install the push rod clevis onto the brake pedal lever with the push rod pin and clip.
9. INSTALL STOP LIGHT SWITCH
(a)
Insert the stop light switch into the adjuster until it just touches the brake pedal.
NOTICE: Do not depress the brake pedal.