FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
![background image](/toyota/fj_cruiser_4wd/v6-4.0l_(1gr-fe)/Page-1329002.png)
6. REMOVE SIDE AIRBAG SENSOR LH
a. Disconnect the connector from the side airbag sensor LH.
b. Remove the bolt and the side airbag sensor LH.
INSTALLATION
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures described below are for the LH side.
1. PRECAUTION
CAUTION: Read PRECAUTION thoroughly before servicing, (Refer to Restraint Systems; Service Precautions).
2. INSTALL SIDE AIRBAG SENSOR LH
a. Check that the ignition switch is turned to OFF.
b. Check that the negative (-) battery terminal is disconnected.
CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.
c. Install the side airbag sensor LH with the bolt.
Torque: 9.0 N.m (92 kgf.cm, 80 in.lbf)