FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
/Page-1329003.png)
NOTE:
-
If the side airbag sensor LH has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it
with a new one.
-
When installing the side airbag sensor LH, make sure that the SRS wiring does not interfere with any other parts and that it is not pinched
between other parts.
d. Check that there is no looseness in the installation parts of the side airbag sensor LH.
e. Connect the connector to the side airbag sensor LH.
3. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
4. INSTALL ACCESS DOOR SCUFF PLATE LH
5. INSTALL FRONT DOOR SCUFF PLATE LH
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N.m (40 kgf.cm, 35 in.lbf)
7. PERFORM INITIALIZATION
a. Perform initialization.
HINT: Some systems need initialization when the cable has been disconnected from the negative battery terminal.
8. INSPECT SRS WARNING LIGHT
a. Inspect the SRS warning light.