FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
![background image](/toyota/fj_cruiser_4wd/v6-4.0l_(1gr-fe)/Page-897005.png)
SST 09332-25010
(e)
Install 4 new snap rings of equal thickness which will allow no axial play.
HINT: Do not reuse the snap rings.
Thickness of snap ring
NOTICE:
^
Use a new snap ring.
^
Use snap rings as close as possible to the same thickness on both ends.
(f)
Using a hammer, tap the yoke until there is no clearance between the spider bearing outer race and the snap ring.
HINT: Install a new spider bearing on the sleeve side in the procedure described above.