FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
(k) Using a plastic hammer, tap the yoke until there is no clearance between the spider bearing outer race and the snap ring.
HINT: Install a new spider bearing on the sleeve side in the procedure described above.
2. INSPECT UNIVERSAL JOINT SPIDER BEARING
(a)
Check that the joints move smoothly.
(b) Check the spider bearing axial play by turning the yoke while holding the shaft tightly.
Maximum bearing axial play: 0 mm (0 in.)
3. INSPECT FRONT PROPELLER SHAFT ASSEMBLY
HINT: When replacing the spider bearing, be sure that the grease fitting hole is facing in the direction shown in the illustration.
INSTALLATION
1. INSTALL FRONT PROPELLER SHAFT ASSEMBLY
(a)
Align the matchmarks on the yoke and differential flange.
(b) Install the propeller shaft assembly with the 4 bolts, 4 nuts and 4 washers.
Torque: 88 N*m (899 kgf*cm, 65 ft.*lbf)