FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
Thickness of snap ring
NOTICE:
^
Use a new snap ring.
^
Use snap rings as close as possible the same thickness on both ends.
(f)
Using a hammer, tap the yoke until there is no clearance between the spider bearing outer race and snap ring.
HINT: Install new spider bearings onto the sleeve side in the procedure described above.
(g) Align the matchmarks on the flange yoke and the sleeve yoke.
(h) Using SST, install the spider bearings onto the spider.
SST 09332-25010
(i)
Using SST, adjust both bearings so that the snap ring grooves are at maximum and equal in width.