Highlander 2WD L4-2.4L (2AZ-FE) (2001)
Wheel Speed Sensor: Service and Repair
Speed Sensor, Front
REPLACEMENT
HINT: Replace the RH side by the same procedures with LH side.
1. REMOVE FRONT WHEEL
2. REMOVE FRONT FENDER LINER LH [53876A/98-97]
3. REMOVE SPEED SENSOR FRONT LH [89543/98-170]
a. Disconnect the speed sensor connector.
b. Remove the 2 clamp bolts holding the sensor harness and clamp from the body and shock absorber.
c. Remove the bolt and speed sensor FR LH.
NOTICE: Do not stick and foreign matter on the sensor tip.
4. INSTALL SPEED SENSOR FRONT LH [89543/98-170]
a. Install the speed sensor FR LH with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)