Highlander 2WD L4-2.4L (2AZ-FE) (2001)
/Page-962002.png)
NOTICE: Do not stick and foreign matter on the sensor tip.
b. Install the sensor harness clamps with the 2 bolts "A" and "B" to the body and shock absorber.
Torque:
Bolt A: 5.0 Nm (51 kgf-cm, 44 inch lbs.)
Bolt B: 29 Nm (296 kgf-cm, 21 ft. lbs.)
c. Connect the clamp to the knuckle.
d. Connect the speed sensor connector.
5. INSTALL FRONT FENDER LINER LH [53876A/98-97]
6. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
7. CHECK ABS SPEED SENSOR SIGNAL