Highlander 2WD V6-3.3L (3MZ-FE) Hybrid (2006)
3. INSTALL STEERING RACK BOOT NO.1 CLAMP
a. Using pliers and a screwdriver, install the steering rack boot No. 1 clamp (LH side).
NOTICE:
^
Be careful not to damage the steering rack boot.
^
Do not twist the steering rack boot.
b. Install the RH side by using the same procedure as for the LH side.
4. INSTALL STEERING RACK BOOT CLIP
a. Using pliers, install the 2 boot clips.
b. Using SST, turn the pinion and check that the rack boots expand and contract smoothly.
SST 09616-00011
5. INSTALL TIE ROD ASSEMBLY
a. Install the lock nut and the tie rod assembly (LH side) to the rack end sub-assembly until the matchmarks are aligned.
HINT: After adjusting toe-in, torque the lock nut.
b. Install the RH side by using the same procedure as for the LH side.
INSTALLATION