Highlander LTD 2WD V6-3.0L (1MZ-FE) (2002)
Control Arm: Service and Repair
Rear
Rear NO.1
REPLACEMENT / Suspension Arm No.1 LH Replacement
HINT: This procedure is provided for the replace on the LH side. Replace the other side in the same way.
1. REMOVE REAR WHEEL
2. REMOVE STABILIZER BAR REAR
3. REMOVE REAR SUSPENSION ARM ASSY NO. 1 LH
a. Remove the bolt and disconnect the rear suspension arm No. 1 (inner side).
b. Remove the bolt, nut and rear suspension arm No. 1 (outer side) from rear axle carrier.
HINT: While fixing the nut, turn and remove the bolt.
4. TEMPORARY TIGHTEN REAR SUSPENSION ARM ASSY NO. 1 LH
a. Install the rear suspension arm No. 1 (inner side) with the bolt, and temporarily tighten the bolt.
HINT: Face the paint mark to the rearward.