Highlander LTD 2WD V6-3.0L (1MZ-FE) (2002)
b. Connect the rear suspension arm No. 1 (outer side) to the rear axle carrier with the bolt and nut, and temporarily tighten the bolt and nut.
HINT: Insert the bolt from the front side of the vehicle and temporarily install the bolt.
5. STABILIZE THE SUSPENSION
6. FULLY TIGHTEN REAR SUSPENSION ARM ASSY NO. 1 LH
a. Fully tighten the bolt.
Torque: 100 Nm (1,020 kgf-cm, 74 ft. lbs.)
b. Fully tighten the bolt.
Torque: 100 Nm (1,020 kgf-cm, 74 ft. lbs.)
HINT: While fixing the nut, turn and install the bolt.
7. INSTALL STABILIZER BAR REAR
8. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
9. INSPECT REAR WHEEL ALIGNMENT
Rear NO.2
REPLACEMENT / Suspension Arm No.2 LH Replacement
HINT: This procedure is provided for the replace on the LH side. Replace the other side in the same way.
1. REMOVE REAR WHEEL
2. REMOVE REAR SUSPENSION ARM ASSY NO. 2 LH (2WD DRIVE TYPE)