MEASURE BEARING PRELOAD - Toyota Land Cruiser J70 Workshop Manual
- Make
- Toyota
- Model
- Land Cruiser Toyota Land Cruiser J70 Workshop Manual
- Section
- Front Axle Suspension › MEASURE BEARING PRELOAD - Toyota Land Cruiser J70 Workshop Manual
MEASURE BEARING PRELOAD


FRONT AXLE AND SUSPENSION — Steering Knuckle and Axle Shaft (d) Using SST, support the lower bearing inner race. SST 09606-60020

NOTE: Use SST witha collar. (e) Install the knuckle arm over the shims that were originally used or were selected in the adjustment operations. (f) Using a hammer, tap the knuckle arm into the bearing inner race. (g) Remove SST from the knuckle. FA0520 FAQN19 Install and torque the nuts. (h) (Knuckle Arm) Install the cone washers, plate washers and torque the nuts. 975kg-cm (71 ft-lb, 96 N-m) Torque: (Third Arm) Install the cone washers, plate washers and torque the nuts. 1,170 kg-cm (85 ft-lb, 115 N-m) Torque: FA0521 FA0522 (Bearing Cap) Install the spring washers and torque the nuts. Torque: 975 kg-cm (71 ft-lb, 96 N-m)


MEASURE BEARING PRELOAD
Using a spring tension gauge, measure the preload. Preload (starting): 2.5 —5.0 kg (5.6 — 11.0 Ib) (26 — 49 N) FA0523
CONNECT TIE ROD TO KNUCKLE ARM

Torque the castle nut and secure it with a cotter pin. Torque: 925 kg-cm (67 ft-lb, 91 N-m)
INSTALL OIL SEAL SET RETAINER TO KNUCKLE

INSTALL AXLE SHAFT
Position one flat part of the outer shaft upward, and in- stall the shaft. pit




+i fe
Donated by Onur Azeri . cruisercult.com
Parts & tools for this job For Toyota Land Cruiser
- TOOLCoil spring compressorSearch: coil spring compressor
- TOOLBall joint separatorSearch: ball joint separator
- PARTFront shock absorbersSearch: Toyota Land Cruiser front shock absorbers
As an Amazon Associate we earn from qualifying purchases.