38261E.pdf - mm (in.) - Toyota Land Cruiser J70 Workshop Manual
- Make
- Toyota
- Model
- Land Cruiser Toyota Land Cruiser J70 Workshop Manual
- Section
- Transfer › 38261E.pdf - mm (in.) - Toyota Land Cruiser J70 Workshop Manual
38261E.pdf - mm (in.)

TRANSFER -— Transfer (d) Temporarily install the rear companion flange lock nut. (e) Using a torque meter, measure the rear output shaft preload, (Starting torque) Preload: New bearing 15 — 24.7 kg-cm (13.0 — 21.4 in.-Ib, 1.5 — 2.4 N-m) Reused bearing 7 — 12 kg-cm (6.1 — 10.4 in.-Ib, 0.7 — 1.2 N-m) ‘Tro242 TFO24) If the preload is not within specification, remove the outer race of the rear output shaft rear bearing with SST. Reselect an adjusting shim.


mm (in.)
| Thickness
mm (in.)| Mark
Mark | Thickness
0
0.15 (0.0059) 10
1.0 (0.039) 4
0.4 (0.016) "
1.1 (0.043) 5
0.5. (0.020) 12
1.2 (0.047) 6
0.6 (0,024) 13
1.3 (0.051) 7
0.7 (0.028) 14
1.4 (0.055) 8
0.8 (0.031) 15
1.5 (0.059) 09 (0.035) 9 |
NOTE: The preload will change about 10.0 kg-cm (8.7 in.-lb, 1.0 N-m) with each shim thickness. (f) Remove the rear companion flange lock nut.
TrO242
22.
REMOVE REAR OUTPUT SHAFT REAR BEARING
RETAINER


10121

INSTALL REAR OUTPUT SHAFT REAR BEARING
23. RETAINER -
Align the bearing retainer rib with the case rib and
(a) install the retainer with a new gasket. (b) Apply liquid sealer to the six bolts. (c) Install and torque the bolts. 350 kg-cm (25 ft-lb, 34 N-m) Torque;


$
Donated by Onur Azeri . cruisercult.com
Parts & tools for this job For Toyota Land Cruiser
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Toyota Land Cruiser
As an Amazon Associate we earn from qualifying purchases.