MR2 Spyder L4-1.8L (1ZZ-FE) (2001)
-
Pull the cruise control switch for CANCEL.
e. Inspect the RES (resume) switch.
1. Push the main switch ON.
2. Drive at a desired speed (40 km/h (25 mph) or higher).
3. When operating one of the followings, check that the cruise control system is cancelled and that the normal driving mode is reset.
-
Depress the brake pedal.
-
Shift into except S position.
-
Pull the cruise control switch for CANCEL.
4. After the control switch is turned to RES/ACC at the driving speed of more than 40 km/h (25 mph), check that the vehicle restores the speed
before the cancellation.
Clearing Diagnostic Trouble Codes
DTC CLEARANCE
NOTE: This is the only information provided by the manufacturer for clearing diagnostic trouble codes for this system.
a. The following actions will erase DTCs and freeze frame data.
1. Operating the OBD II scan tool (complying with SAE J1978) or TOYOTA hand-held tester to erase the codes (See the OBD II scan tool's
instruction book for operating instructions.).
2. Disconnecting the battery terminals or EFI1 fuse.
b. After completing repairs, the DTC retained in the memory can be cleared by removing the ECU-B fuse for 10 seconds or more with the ignition
switch OFF.
c. Check that the normal code is displayed after connecting the fuse.
Displaying & Reading Trouble Codes
NOTE: This is the only information provided by the manufacturer for reading diagnostic trouble codes for this system.
PRE-CHECK
1. DIAGNOSIS SYSTEM
a. Check the indicator.
1. Turn the ignition switch ON.
2. Check that the CRUISE main indicator light comes on when the cruise control main switch is turned ON, and that the indicator light goes
off when the main switch is turned OFF.
HINT: If the indicator check result is not normal, proceed to troubleshooting for the combination meter.