MR2 Spyder L4-1.8L (1ZZ-FE) (2001)
c. Using SST and 2 bolts (Diameter: 12 mm, Pitch: 1.5 mm), remove the ABS speed sensor.
SST 09520-00031 (09520-00040, 09521-00020), 09950-00020
NOTICE:
-
Do not allow any foreign matter to stick to the sensor rotor.
-
Pull out the ABS speed sensor straightly not to damage the sensor rotor.
-
If the sensor rotor is damaged, replace the axle hub assembly.
-
Do not scratch the contacting surface of the axle hub and speed sensor.
REASSEMBLY
INSTALL NEW ABS SPEED SENSOR
a. Clean the contacting surface of the axle hub and a new ABS speed sensor.
NOTICE: Do not allow any foreign matter to stick to the sensor rotor.
b. Place the ABS speed sensor on the axle hub so that the connector is set at the bottom under the on-vehicle condition.
c. Using SST and a press, install a new ABS speed sensor to the axle hub.
SST 09527-10011, 09710-04101, 09950-60020 (09951-00680)
NOTICE:
-
Do not tap the speed sensor with a hammer directly.
-
Check that there should be no foreign matter on the speed sensor detection portion.
-
Press in the ABS speed sensor straightly and slowly.