Pickup 4WD L4-2366cc 2.4L SOHC (22R) (1984)
/Page-175008.png)
(b) Apply seal packing to the joint part of the cylinder block and chain cover, cylinder block and rear oil seal retainer.
Seal packing: Part No.08826-00080 or equivalent
(c) Apply seal packing to the oil pan as shown in the figure.
Seal packing: Part No.08826-00080 or equivalent
^ Install a nozzle that has been cut to a 5-mm (0.20 in.) opening.
NOTE: Avoid applying an excess amount to the surface. Be especially careful near oil passages.
^ Parts must be assembled within 5 minutes of application. Otherwise, the material must be removed and re-applied.
^ Immediately remove nozzle from tube and reinstall cap.
(d) Install the oil pan over the studs on the block with sixteen bolts and two nuts. Torque the bolts and nuts.
Torque: 130 kg-cm (9 ft-lb, 13 N.m)
(e) Lower the engine and install the engine mounting bolts.
(f) Install the engine under cover.
POST INSTALLATION
1. INSTALL RADIATOR
2. INSTALL CYLINDER HEAD
