Pickup 4WD L4-2366cc 2.4L SOHC (22R) (1984)
/Page-175007.png)
7. INSTALL NO.1 WATER BY-PASS PIPE
(22R) Install the pipe with the three bolts.
(22R-E) Install the pipe with the two bolts.
(22R-TE) Connect the pipe to the timing chain cover with the two bolts.
8. INSTALL CRANKSHAFT PULLEY
(a) Install the crankshaft pulley and bolt.
(b) Using SST to hold the crankshaft pulley, torque the bolt.
SST 09213-70010 and 09330-00021
Torque: 1600 kg-cm (116 ft-lb, 157 N.m)
(c) (with A/C) Install the No.2 crankshaft pulley.
9. INSTALL WATER PUMP PULLEY AND FLUID COUPLING WITH FAN
(a) Temporarily install the water pump pulley and fluid coupling with fan with four nuts.
(b) Place the drive belt on to each pulley.
(c) Stretch the belt tight and tighteen the four nuts.
10. ADJUST DRIVE BELT TENSION
11. (with A/C) INSTALL A/C COMPRESSOR BRACKET, COMPRESSOR AND BELT
12. (with PS) INSTALL PS BELT
13. INSTALL OIL PAN
(a) Remove any old packing material and be careful no to drop any oil on the contacting surfaces of the oil pan and cylinder block.
^ Using a razor blade and gasket scraper, remove all the packing (FIPG) material from the gasket surfaces.
^ Thoroughly clean all components to remove all the loose material.
^ Clean both sealing surfaces with a non-residue solvent.
CAUTION: Do not use a solvent which will affect the painted surfaces.
