Pickup 4WD L4-2366cc 2.4L SOHC (22R) (1984)
3. INSTALL OIL PUMP DRIVE SPLINE
Slide the oil pump drive spline over the crankshaft key.
NOTE: If the oil pump drive spline is difficult to install by hand, install using SST.
SST 09608-35014 (09608-06040)
4. INSTALL TIMING CHAIN COVER ASSEMBLY
(a) Remove the old cover gaskets. Clean the gasket surface. Install new gaskets over the dowels.
(b) Slide the cover assembly over the dowels and pump spline.
(c) Insert the bolts as shown and torque them.
Torque:
8mm bolt 130 kg-cm (9 ft-lb, 13 N.m)
10mm bolt 400 kg-cm (29 ft-lb, 39 N.m)
5. INSTALL FAN BELT ADJUSTING BAR
(a) Temporarily install the adjusting bar to the alternator.
(b) Install the adjusting bar to the chain cover and cylinder head.
Torque: 130 kg-cm (9 ft-lb, 13 N.m)
6. (22R, 22R-E) INSTALL HEATER WATER OUTLET PIPE
Connect the heater water outlet pipe to the timing gear cover with two bolts.
(22R-TE) INSTALL NO.3 TURBO WATER PIPE
Install the No.3 turbo water pipe with the two bolts.