Prius L4-1.8L (2ZR-FXE) Hybrid (2010)
_hybrid/Page-712002.png)
Position the bearings to the center of the bearing cap by measuring dimension A.
3. INSTALL NO. 2 CAMSHAFT
(a) Clean the camshaft journals.
(b) Apply a light coat of engine oil to the camshaft journals, camshaft housings and bearing caps.
(c) Install the No. 2 camshaft to the camshaft housing.
4. INSTALL CAMSHAFT
(a) Clean the camshaft journals.
(b) Apply a light coat of engine oil to the camshaft journals, camshaft housings and bearing caps.
(c) Install the camshaft to the camshaft housing.
5. INSTALL BEARING CAP
(a) Apply engine oil to the camshaft journals, camshaft housings and bearing caps.
(b) Make sure of the marks and numbers on the camshaft bearing caps and place them in each proper position and direction.
(c) Tighten the 10 bolts in the order shown in the illustration.
Torque : 16 Nm (163 kgf-cm, 12 ft-lbf)
6. INSTALL CAMSHAFT HOUSING SUB-ASSEMBLY
(a) Check that the valve rocker arms are installed as shown in the illustration.
