Prius L4-1.8L (2ZR-FXE) Hybrid (2010)
(b) Apply seal packing in a continuous line as shown in the illustration.
Seal packing:
Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent
Standard Seal Diameter:
Application Length A and B:
15 mm (0.591 in.)
NOTICE:
*
Remove any oil from the contact surfaces.
*
Install the camshaft housing within 3 minutes and tighten the bolts within 10 minutes of applying seal packing.
*
Do not start the engine for at least 2 hours after installation.
(c) Set the camshaft and No. 2 camshaft as shown in the illustration.
(d) Install the camshaft housing with the 17 bolts and tighten them in the order shown in the illustration.
Torque : 27 Nm (275 kgf-cm, 20 ft-lbf)
NOTICE:
*
After installing the camshaft housing, make sure that the cam lobes are positioned as shown in the illustration.
*
If any of the bolts is loosened during installation, remove the camshaft housing, clean the installation surfaces, and reapply seal