RAV4 2WD L4-2.5L (2AR-FE) (2009)
(a) Install the exhaust manifold heat insulator with the 4 bolts.
Torque: 12 Nm (122 kgf-cm, 9 ft-lbf)
5. INSTALL NO. 2 MANIFOLD STAY
(a) Install the stay with the bolt and nut.
Torque: 43 Nm (438 kgf-cm, 32 ft-lbf)
6. INSTALL MANIFOLD STAY
(a) Install the stay with the bolt and nut.
Torque: 43 Nm (438 kgf-cm, 32 ft-lbf)
7. INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) See: Powertrain Management/Computers and Control Systems/Oxygen
Sensor/Service and Repair/Air Fuel Ratio Sensor/Installation
8. INSTALL RADIATOR HOSE CLAMP See: Cooling System/Radiator/Service and Repair/Removal and Replacement/Installation
9. INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE See: Engine/Service and Repair/Removal and Replacement/Engine Unit/Installation
10. INSTALL ENGINE OIL LEVEL DIPSTICK
11. INSTALL FRONT EXHAUST PIPE ASSEMBLY
(a) Using a vernier caliper, measure the free length of the compression spring.
Minimum length:
41.5 mm (1.63 in.)
If the length is less than the minimum, replace the compression spring.
(b) Using a wire brush, remove any foreign matter from the gasket installation surface.