RAV4 4-Door 4WD L4-2.0L (3S-FE) (1997)
Transmission Position Switch/Sensor: Service and Repair
PARK/NEUTRAL POSITION SWITCH REPLACEMENT
1. Remove No.2 engine under cover.
2. Disconnect park/neutral position switch connector.
3. Remove park/neutral position switch.
a. Remove the nut and disconnect the shift control lever.
b. Remove the nut and shift control
c. Using a screwdriver, pry off the lock plate.
d. remove the nut and lock plate.
e. Remove the 2 bolts and pull out the park/neutral position switch.
4. Install and adjust park/neutral position switch.
a. Install the park/neutral position switch to the manual valve shaft with the 2 bolts and nut.
b. Install a new lock plate and tighten the nut.
Torque: 6.9 N.m (61 inch lbs.)
c. Stake the nut with the lock plate.
d. Temporarily install the manual shaft lever.