RAV4 4WD L4-2.4L (2AZ-FE) (2007)
d. Fold back approximately half of each cushion rubber so that the wire harness can be detached from the fuel tank in the step below.
e. Disconnect the fuel pump connector and sender gauge connector.
NOTE:
-
Before this procedure, check the connector for dirt, mud or other contamination.
-
Do not use any tools in this procedure.
f.
Detach the wire harness from the 4 clamps and remove the fuel tank.
INSTALLATION
1. INSTALL FUEL TANK ASSEMBLY
a. Set the fuel tank on a transmission jack.
b. Lift up the transmission jack.
c. Fold back the 2 cushion rubbers.
d. Connect the fuel pump connector and sender gauge connector to the fuel tank.
NOTE: Be careful not to cut the wirings.