Sequoia 2WD V8-4.6L (1UR-FE) (2010)
/Page-1096089.png)
(1) Disconnect the O18 suspension control ECU connector.
(2) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(b) w/o AVS:
(1) Disconnect the O19 suspension control ECU connector.
(2) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPAIR OR REPLACE CAN MAIN WIRE CONNECTED TO SUSPENSION CONTROL ECU (CANH, CANL)
OK -- REPLACE SUSPENSION CONTROL ECU See: Relays and Modules/Relays and Modules - Steering and Suspension/Relays
and Modules - Suspension/Suspension Control Module/Service and Repair/Removal
28. CHECK FOR SHORT TO GND IN CAN BUS WIRE (COMBINATION METER ECU)
(a) Disconnect the H37 combination meter ECU connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance: