Sequoia 4WD V8-4.6L (1UR-FE) (2010)
(e) If the result is not as specified, there may be a malfunction on the wire harness side.
(f) Connect the W8 heater control connector.
(g) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
(h) If the result is not as specified, the seat heater control may have a malfunction.
3. INSPECT SEAT HEATER CONTROL SUB-ASSEMBLY LH (for Rear No. 1 Seat)
(a) Disconnect the O43 heater control connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance: