Sequoia 4WD V8-4.6L (1UR-FE) (2010)
![background image](/toyota/sequoia_4wd/v8-4.6l_(1ur-fe)/Page-2943008.png)
(c) If the result is not as specified, there may be a malfunction on the wire harness side.
(d) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
(e) If the result is not as specified, there may be a malfunction on the wire harness side.
(f) Connect the O43 heater control connector.
(g) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
HINT
*
When the heater reaches the specified temperature, the power turns off.
*
If the result is not as specified, the seat heater control may have a malfunction.
4. INSPECT SEAT HEATER CONTROL SUB-ASSEMBLY RH (for Rear No. 1 Seat)
(a) Disconnect the P23 heater control connector.