Sequoia 4WD V8-4.6L (1UR-FE) (2010)
18. CONNECT REAR DISC BRAKE CYLINDER ASSEMBLY RH
HINT
Use the same procedure for both sides.
19. INSTALL REAR WHEEL LH See: Steering and Suspension/Suspension/Suspension Strut / Shock Absorber/Service and Repair/Removal and
Replacement/Rear Shock Absorber/Installation
20. INSTALL REAR WHEEL RH
HINT
Use the same procedure for both sides.
21. CONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY See: Parking Brake Pedal/Service and Repair/Removal and
Replacement/Installation
22. INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY
(a) Install the No. 1 parking brake cable to the inside of the vehicle with the 2 bolts (labeled A).
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
(b) Connect the clamp (labeled B) to the No. 1 parking brake cable.
(c) Install the clamp with the nut (labeled C).
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
(d) Install the No. 1 parking brake cable and cable retainer with the bolt (labeled D).
Torque : 13 Nm (128 kgf-cm, 9 ft-lbf)
(e) Temporarily install the adjustment nut and lock nut (labeled E).
NOTICE:
Do not bend and twist the parking brake cable.
HINT
The nuts will be tightened to a torque specification in the "Adjust Parking Brake Pedal Travel" procedure.