Sequoia 4WD V8-4.6L (1UR-FE) (2010)
Crankshaft Main Bearing Seal: Service and Repair
Installation
1UR-FE ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL: INSTALLATION
1. INSTALL REAR CRANKSHAFT OIL SEAL
(a) Apply MP grease to the lip of a new oil seal.
(b) Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
SST : 09223-56010
NOTICE:
*
Keep the lip free from foreign matter.
*
Do not tap on the oil seal at an angle.
2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY See: Service and Repair/Removal and Replacement/Engine
Assembly/Installation
3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY
(a) for 2WD:
Refer to the following procedures .
(b) for 4WD:
Refer to the following procedures See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Removal and
Replacement/Installation.
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning.