Sequoia 4WD V8-4.6L (1UR-FE) (2010)
EGR Cooler: Service and Repair
Installation
1UR-FE EMISSION CONTROL: EGR COOLER: INSTALLATION
1. INSTALL NO. 2 EGR PIPE SUB-ASSEMBLY
(a) Install a new gasket and the No. 2 EGR pipe with the 2 bolts.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
NOTICE:
Make sure the gasket's claws are not caught between the No. 2 EGR pipe and EGR cooler.
2. INSTALL EGR COOLER ASSEMBLY
(a) Install the EGR cooler with the 2 bolts.
Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)
3. INSTALL NO. 1 EGR PIPE SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Manifold/Service and
Repair/Installation
4. CONNECT NO. 11 WATER BY-PASS HOSE
(a) Connect the No. 11 water by-pass hose.
HINT
The direction of the hose clamp is indicated in the illustration.
5. CONNECT NO. 8 WATER BY-PASS HOSE