Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
Garage Door Opener Transmitter: Service and Repair
Registration Procedure
REGISTRATION PROCEDURE
1. NEW CODE REGISTRATION
NOTE: If pressing the switch of the original transmitter to register the code, the system might operate.
When registering the transmitter codes such as for garage or gate, check that there is nobody around those places then register.
a. Press the switch for the item to be registered for 20 seconds
HINT: When transferring to registration mode, garage door indicator (green) blinks in 1 Hz cycle.
b. In the condition of (a), bring the original transmitter to within 1-inch area around the garage door opener and press the switch. (code
transmitting).
HINT: When code registration completes correctly, garage door indicator (green) blinks in 5.6 Hz cycle.
New code registration timing chart
If a code can not be registered, observe the following conditions.
HINT:
-
If the battery of original transmitter is consumed.
-
Press the switch of the transmitter repeatedly in registration mode, as some transmitters stop transmitting for 1 to 2 seconds.
-
This system is not applicable to the garage door opener which had been made before 1982.
2. CODE DELETION